Filter
Top Products
7 - 5
Scan the following bar code to set the communication check character type. Default = None.
Intercharacter, Interfunction, and Intermessage Delays
Some terminals drop information (characters) if data comes through too quickly. Intercharacter, interfunction, and intermessage
delays slow the transmission of data, increasing data integrity.
Intercharacter Delay
An intercharacter delay of up to 65535 milliseconds (in 1ms increments) may be placed between the transmission of each
character of scanned data. Scan the Intercharacter Delay bar code below, then scan the number of 1ms delays, and the
Save bar code using the Programming Chart inside the back cover of this manual.
To remove this delay, scan the Intercharacter Delay bar code, then set the number of delays to 0. Scan the Save bar code
using the Programming Chart inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 65535 milliseconds (in 1ms increments) may be placed after the transmission of a particu-
lar character of scanned data. Scan the Delay Length bar code below, then scan the number of 1ms delays, and the Save
bar code using the Programming Chart inside the back cover of this manual.
* None
LRC Starts on 1st Character
LRC Starts on 2nd Character
CRC
1 2345
Intercharacter Delay
Prefix Scanned Data Suffix
Intercharacter Delay