Filter
Top Products
9 - 31
UPC-A Addenda Required
When Required is scanned, the scanner will only read UPC-A bar codes that have addenda. You must then turn on a 2 or
5 digit addenda listed on page 9-30. Default = Not Required.
UPC-A Addenda Separator
When this feature is on, there is a space between the data from the bar code and the data from the addenda. When turned
off, there is no space.
Default = Off.
UPC-A Redundancy
If you are encountering errors when reading UPC-A bar codes, you may want to adjust the redundancy count. Redundancy
adjusts the number of times a bar code is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy, scan the UPC-A
Redundancy bar code below, then scan a redundancy count between 0 and 10 on the Programming Chart inside the back
cover of this manual. Then scan the Save bar code. Default = 0.
UPC-A/EAN Addenda Redundancy
This programs the number of redundant scans required of a 2 or 5-digit addendum before it is attached to the UPC or EAN
bar code and submitted. To adjust the redundancy, scan the Redundancy bar code below for the 2 or 5-digit addenda you
want to adjust, then scan a redundancy count between 0 and 10 on the Programming Chart inside the back cover of this
Required
* Not Required
On
* Off
UPC-A Redundancy