Filter
Top Products
9 - 15
Matrix 2 of 5
Matrix 2 of 5 On/Off
Check Digit
No Check Digit indicates that the scanner reads and transmits bar code data with or without a check digit.
When Check Digit is set to Validate, but Don’t Transmit, the unit only reads Matrix 2 of 5 bar codes printed with a check
digit, but will not transmit the check digit with the scanned data.
When Check Digit is set to Validate and Transmit, the scanner only reads Matrix 2 of 5 bar codes printed with a check
digit, and will transmit this digit at the end of the scanned data. Default = No Check Digit.
Matrix 2 of 5 Redundancy
If you are encountering errors when reading Matrix 2 of 5 bar codes, you may want to adjust the redundancy count. Redun-
dancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number of errors.
Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy, scan
the Matrix 2 of 5 Redundancy bar code below, then scan a redundancy count between 0 and 10 on the Programming
Default All Matrix 2 of 5 Settings
On
* Off
* No Check Digit
Validate, but Don’t Transmit
Validate and Transmit