Filter
Top Products
1 - 4
Push Button Functionality
There is a ring of 4 push buttons on the front of the device. The following is a brief description of the default settings for the push
buttons. For complete functionality and programming options, refer to Button Controls on page 4-4.
Note: Pressing the Sound button wakes the scanner from sleep mode.
Scale Zero
This button is normally lit when the scale is at zero. The backlight goes off when the scale is not at zero. Press this button
to reset the scale to zero.
Image Capture
Press this button once to scan a bar code using a customer-facing scanner (if installed). Push it a second time to disable
the customer-facing scanner. See Image Capture Button on page 4-7 for further information.
Sound
Press repeatedly to scroll through the beeper volumes. This button is also used to clear error conditions (LED lights,
beeps, and LCD notifications). Hold this button down for 5 seconds to put the scanner to sleep.
Green, Red, Yellow Flash Auxiliary Scanner Beep Auxiliary Scanner Configuration
Green, Red, Yellow Flash With or without Beep
Scale Calibration
Red Flash Razz Error Event - Minor (See Troubleshooting a
Stratos Bioptic Scanner, beginning on page
15-1)
Red Flash, then Continuous Razz Error Event - Major (See Troubleshooting a
Stratos Bioptic Scanner, beginning on page
15-1)
Green Flash Cuckoo Beep
Configuration Code - Temporary
Green Flash Ascending 3 Tone
Configuration Code - Permanent
LEDs (Continued) Sound Indication
Push Buttons