Filter
Top Products
Using HTML Forms
175
• Preferred File Server. In a bindery setup, this specifies the file
server that the print server object was created on. In an NDS
setup, this specifies a file server(s) that the print server object
resides on. Since NDS is distributed, most administrators will
not know which file server(s) the print server object is actually
stored on, so in most NDS environments this option is not used.
For additional information about these options, see “Novell
Configuration For 10/100Base-T Interfaces” on page 191.
Using HTML Forms
ADAPTER,
WIRELESS
ADAPTER
When defining a new print queue on a Novell file server, a new print
server must be defined to represent the Ethernet Interface. This
name must match the predefined name given to the print server.
The default print queue name is M_xxxxxx, where xxxxxx
represents the last six digits of the Ethernet Interface address found
on the configuration printout or control panel settings under
Ethernet Parameters, MAC address (e.g., M_091C1A)
To use the HTML forms to define a print queue, do the following:
1. Load a Web browser on a network station that can
communicate with the print server over TCP/IP. The command
to change the print server name is:
Syntax:
store pserver name newname
Example to change the name to micro1:
store pserver name micro1
2. Direct your Web browser to URL:
http://EthernetInterfaceIPaddress/
adminConf.html
(e.g., http://192.75.11.9/adminConf.html).
NOTE: If prompted for a “User ID” and password first, type in root
for the ID and press ENTER at the password prompt (since
there is no password by default).