Filter
Top Products
Chapter 1 Interfaces
42
Interfaces
The Ethernet interfaces with your printer through an Ethernet™
10/100Base-T interface connector.
10/100Base-T
ADAPTER
The Ethernet Interface at the rear of the printer for the 10/100Base-
T interface has two indicator lights and two DIP switches, as shown
in Figure 2.
Figure 2. Status Indicator Lights and DIP Switches
Run and Auto Reset Modes
Run mode is the normal operating state of the Ethernet Interface.
Auto Reset mode is entered when the watchdog timer is triggered
and the Print Server resets itself. In either mode, the STAT LED
flashes at a varying rate, depending on whether the unit IP address
is configured. The Run Mode and Auto Reset Mode indicator
descriptions are given in Table 1.
1
2
STAT (System Status)
NET (Data to Network)
DIP Switches