Filter
Top Products
Chapter 16 Complete Command List
356
set var from default
Set all variable settings back to factory defaults.
set var from stored
Set all current variable settings to the values stored in flash
memory.
List Commands
These commands list the current or working settings for a particular
section within the command shell. To view stored settings in flash
memory, insert stored after list. For example, list prn
shows the current printer settings but list stored prn shows
the settings in flash memory. Normally these should match.
list all
Lists all current settings.
list arp
List the current ARP table that the Ethernet Interface adheres
to in a TCP/IP network.
list dest [destination]
List the current destination settings (e.g., names and mapped
I/O ports, models, and logpaths).
list diff
List the differences between the current settings and the stored
settings in flash memory. Normally, you want these values to
match, so issue a
save command followed by a reset
command.
list ifc
List the current UTP interface settings (e.g., link integrity).