Filter
Top Products
Chapter 8 iSeries ASCII Troubleshooting
240
Web Browser/HTTP Problem
In some cases you may not be able to browse the printer Web page
simply because the Ethernet Interface HTTP may be turned off.
If you cannot
ping
the Ethernet Interface IP address, make sure
the IP address, subnet mask, and default gateway are set correctly
by checking the ETHERNET PARAMS menu from the control
panel. See the
User's Manual
for configuration menu information.
If you can
ping
the Ethernet Interface IP address but cannot
access the Web pages, perform the following procedure to verify
the Ethernet Interface HTTP is turned on:
1. Telnet into the Ethernet Interface and log in as root with no
password.
2. At the system prompt, enter the following commands:
config http on
save
reset
3. After approximately 5 minutes, point your browser to the
Ethernet Interface IP address. The printer Web pages should
now be accessible.