Filter
Top Products
NetWare Version 4.x and 5.x PSERVER Setup
183
10. Type the name of the Ethernet Interface. The default is
M_xxxxxx, where xxxxxx represents the last six digits of the
network adapter's Ethernet address (e.g., M_091C1A).
11. Select this new print server and press ENTER.
12. Select PRINTERS.
13. Press INSERT to add a new printer (d1prn) to the list.
14. Select this new printer and press ENTER. Go to the Type field.
15. Press ENTER at this field and select DEFINED ELSEWHERE.
If DEFINED ELSEWHERE is not available, choose PARALLEL.
16. Press ENTER on the Print Queues Assigned field.
17. Press INSERT to display all queues; select the one you defined
in step 5 and press ENTER.
18. Select a priority and press ENTER. Priority 1 should be
sufficient.
19. Press ESCAPE, saving your changes, until you are back to
Main Menu.
20. Reboot the Print Server by repowering the printer.
21. Check the CURRENTLY ATTACHED SERVERS and verify the
print server is active.
22. Press ESCAPE until you are out of the PCONSOLE.
Even though the entire print set up is done through PCONSOLE,
you may want to communicate directly with the print server to
modify settings, monitor the unit, etc. To communicate with the print
server, the optional host software, npsh.exe, is included.
npsh.exe is a DOS executable program that can be run from a
DOS prompt on a NetWare workstation.