Filter
Top Products
Store Commands
335
store pping from default
Example:
store pping from default
Store all the periodic ping default setting to flash memory so
taht they are retained after power up.
store pserver from default
Set all general print server settings back to factory defaults.
store pserver from current
Store all current general print server settings to flash memory
so they are retained after a power cycle. This ensures all
current settings match what is stored in flash memory.
store pserver name
Example:
store pserver name NIC1234
Command to change the print server name.
store pserver opts [[-]jobsecurity] [jobtimeout
seconds]
Example:
store pserver opts jobsecurity jobtimeout 5
If jobsecurity is disabled, any user can cancel queued jobs
on the Ethernet including guest users. If jobtimeout is set to
some value other than 0, the Ethernet will only wait this amount
of seconds when getting printer feedback. This is only used if
you have a logpath port and type set on a particular destination.
store pserver opts [[-]jobsecurity]
[jobtimeout <seconds>] [jobcontrol[off|standard|
enhanced]]
Example:
store pserver opts [-]jobcontrol
If jobcontrol is disabled then the need for start of job / end of
job flow control with the printer is determined by the printer. Job
flow control is used for jobs requiring backchannel responses
such as IPDS, TN and PJL jobs only. This is available as a
performance enhancement for LPR, TCP socket printing etc.
The job flow control has no affect on IPDS, TN, and PJL jobs.
These options perform their own control. When jobcontrol is
enabled all jobs will be supported with job flow control.
NOTE: When jobcontrol is disabled, dynamic config loading on a
model change is also disabled.