Filter
Top Products
Chapter 17 Ethernet Interface Security
370
If the list is empty, all hosts have access to the Ethernet
Interface services. If there are entries in the list, only those
hosts specified have access to printing and remote command
execution.
To add and delete access list entries, the commands are:
Syntax:
store tcpip tcp access add|del hostIPaddress|
networkaddress
reset
where
hostIPaddress
is the IP address of a TCP/IP host on
your network and
networkaddress
is the address of a subnet on
your network.
Example:
store tcpip tcp access add 192.75.11.25
store tcpip tcp access add 192.75.12.0
store tcpip tcp access del 192.75.11.25
reset
NOTE: Although the maximum number of entries in the access list
is 10, each entry can refer to a network rather than a
specific host. This allows all hosts on that specified network
and any individual hosts specified in the list to have access.