Filter
Top Products
Chapter 2 Configuration Tools
56
n. Wait for “ETHERNET IS READY” to display.
o. Press RETURN + ENTER to lock the printer menu.
7. Put the printer online and wait for the “ETHERNET IS READY”
message to display on the front panel. Placing the printer
online starts the Ethernet Interface IP Address and Netmask
update process. This process will take several minutes.
NOTE: If you do not put the printer online, the setting you just
entered will not take effect. Do not turn the printer off until
you see the “ETHERNET IS READY” message. If you turn
the printer off before the new values are written to memory
in the Ethernet Interface adapter, you will need to repower
the printer and repeat steps 6 and 7 above immediately.
8. Once the “ETHERNET IS READY” message displays, you may
enter the Gateway Address by repeating front panel steps 6
and 7 above. This will ensure the correct Netmask becomes
associated with the Gateway value you enter. From the front
panel navigate to the Gateway Address and enter the
appropriate value. You must press ENTER after inputting each
segment of the Gateway Address.
9. Put the printer online and wait for the “ETHERNET IS READY”
message to display on the front panel.
10. Enable the Power Saver mode if desired.