Filter
Top Products
110 Hardware Maintenance Manual: xSeries 250
1. Power-off the server off, if it is on.
2. Disconnect the power cord for each power source from the electrical outlet.
Attention: The presence of ac standby power might result in damage to the
hardware unless you disconnect the power cord for each power source from the
electrical outlet.
3. Remove the top cover (see “Removing the top cover” on page 59).
4. Disconnect the shuttle (see “Disconnecting the shuttle” on page 108.)
5. Remove the shuttle (see “Removing the shuttle” on page 115).
6. Remove the four shuttle screws (two on each side).
7. Push in on the shuttle touchpoints.
8. Separate the shuttle from the I/O Legacy board.
9. To replace the I/O Legacy board, reverse this procedure.
Memory card removal
Before you begin:
• Read “Safety information” on page 180.
• Review “Before you begin” on page 58.