Filter
Top Products
164 Hardware Maintenance Manual: xSeries 250
2. If original ISPR code is still present after disconnecting all SCSI cables and
rebooting, perform the following actions until the error is no longer present:
• Reseat the controller.
• Replace the controller.
ServeRAID
This index supports ServeRAID 3HB Adapters and Controllers. It lists symptoms,
errors, and possible causes.
Note: Do not replace any FRU until you have followed the POST (ISPR) error
procedures (see “ServeRAID POST (ISPR) error procedures” on page 162).
Only replace a ServeRAID 3HB Adapter or controller if ind8icated to do so in
the POST (ISPR) error procedures.
Error Code/Symptom Action
1xxx (flash checksum error) 1. ServeRAID 3HB Adapter/Controller
2xxx (code DRAM error) 1. Install download jumpers, flash latest level
BIOS and firmware for adapter. Remove
jumpers.
2. ServeRAID 3HB Adapter/Controller
2601 to 260B (POST detected error with
ServeRAID subsystem)
1. Install download jumpers, flash latest level
BIOS and firmware for adapter. Remove
jumpers.
2. ServeRAID 3HB Adapter/Controller
2610 (POST detected error with
ServeRAID controller hardware)
1. Install download jumpers, flash latest level
BIOS and firmware for adapter. Remove
jumpers.
2. ServeRAID 3HB Adapter/Controller
2620 (POST detected ServeRAID
configuration or hard disk error)
1. Install download jumpers, flash latest level
BIOS and firmware for adapter. Remove
jumpers.
2. ServeRAID 3HB Adapter/Controller
3xxx (NVRAM error) 1. Install download jumpers, flash latest level
BIOS and firmware for adapter. Remove
jumpers.
2. ServeRAID 3HB Adapter/Controller
4xxx (timer/cache memory controller
error)
1. Install download jumpers, flash latest level
BIOS and firmware for adapter. Remove
jumpers.
2. ServeRAID 3HB Adapter/Controller
5xxx (cache memory controller error) 1. Install download jumpers, flash latest level
BIOS and firmware for adapter. Remove
jumpers.
2. ServeRAID 3HB Adapter/Controller
6xxx (cache DRAM error) 1. Reseat Cache Memory SIMM
2. Install download jumpers, flash latest level
BIOS and firmware for adapter. Remove
jumpers.
3. ServeRAID 3HB Adapter/Controller