Filter
Top Products
Specifying settings using PageScope Web Connection
8
200/250/350 8-65
Specifying settings using PageScope Web Connection Chapter 8
8.17 LDAP Server Setting (Administrator mode)
If LDAP searches are enabled, the LDAP server to be accessed can be reg-
istered. Up to 5 LDAP servers can be registered in this machine.
For details on the LDAP search methods, refer to “Searching the destination
information from the server” on page 7-2.
2
Reminder
If “LDAP” is not set to “Enable”, the LDAP server information cannot be
registered. To register the LDAP server information, be sure to set
“LDAP” to “Enable”.
If “LDAP Server Setting” is clicked, settings can be specified for the follow-
ing.
Item Description
LDAP Server
Name
Enter the LDAP server name. Up to 16 characters can be entered.
LDAP Server
Address: IP
Address
Specify the IP address of the LDAP server.
LDAP Server
Address: Host
Name
Enter the LDAP server host name. Up to 64 characters can be entered.
SSL/TLS Select whether to perform SSL/TLS encryption of the sent data.
Port Number Type in the port number (between 1 and 65535) used to communicate with the
LDAP server.
Search Base Specify the location on the LDAP server where searches are to be started. Up
to 255 characters can be entered.
Connection
timeout
Type in the time (between 5 and 300 seconds) when a search is timed out.
Maximum
number of
Search
Type in the maximum number of hits (between 5 and 100) to be received as
LDAP search results.
Authentication
Setting
Select the LDAP authentication method.
Domain Name Specify a setting when “Authentication Setting” is set to “Active Directory”.
Up to 64 characters can be entered.
Login Name Specify a setting when “Authentication Setting” is not set to “Anonymous”.
Up to 64 alphanumeric characters and symbols can be entered, excluding ^.
Password Specify a setting when “Authentication Setting” is not set to “Anonymous”.
Up to 32 alphanumeric characters and symbols can be entered, excluding ^.
[Check
connection]
Click to use the entered settings and check the connection to the LDAP
server.