Filter
Top Products
8
Specifying settings using PageScope Web Connection
8-70 200/250/350
Specifying settings using PageScope Web Connection Chapter 8
SMTP
* If the setting of a parameter marked with [*] is changed, turn this machine off, then on again.
2
Note
The following parameters appear when bits 6 and 2 of mode 380 are set
to “1” in the Software Switch Setting screen. For details, refer to “Speci-
fying software switch settings (machine functions)” on page 9-29.
- SMTP Authentication User Name
- SMTP Authentication User Password
If bit 4 of mode 371 is set to “1” in the Software Switch Setting screen,
two SMTP servers can be registered. For details, refer to “Specifying
software switch settings (machine functions)” on page 9-29.
Item Description
SMTP Server
Address
Specify a setting for sending data with the Scan to E-mail or Internet fax
operation. In addition, specify a setting when using the E-Mail Notification
function with the Scan to FTP, Scan to SMB or Scan to HDD operation.
Type in the IP address or host name (up to 64 characters). For details on the
settings to be specified, contact the network administrator.
Port Number [*] Type in the number (between 1 and 65535) of the port where the SMTP server
is connected.
SMTP TX
Timeout [*]
Select the time until the connection with the SMTP server is timed out. Select
from 30, 60, 90, 120, 150, 180, 210, 240, 270, and 300 seconds.
SMTP RX
Timeout [*]
Select the time until the connection with the SMTP server is timed out. Select
from 30, 60, 90, 120, 150, 180, 210, 240, 270, and 300 seconds.
E-Mail Address Specify the e-mail address (up to 64 characters) of this machine. This address
appears as the From address when sending data with the Scan to E-Mail or
Internet fax operation.
For details on the settings to be specified, contact the network administrator.
SMTP Authen-
tication User
Name
Specify the user name for using e-mail transmission authentication (SMTP au-
thentication). For details on the settings to be specified, contact the network
administrator.
It is not necessary to specify a setting when the SMTP authentication user
name and the POP3 user name are the same.
SMTP Authen-
tication User
Password
Specify the password for using e-mail transmission authentication (SMTP au-
thentication). For details on the settings to be specified, contact the network
administrator.
It is not necessary to specify a setting when the SMTP authentication pass-
word and the POP3 password are the same.
2
Note
The entered password appears as “••••”. To correct the en-
tered password, clear “••••”, and then type in the correct pass-
word.