Filter
Top Products
Specifying management settings
9
200/250/350 9-53
Specifying management settings Chapter 9
Specifying settings to limit the use of communication modes-1 (mode
475)
Specify whether to permit or prohibit the use of individual communication
modes. Prohibited communication modes do not appear in their selection
screens.
2
Note
Programmed one-touch dial buttons can be used for transmission even
if a prohibited communication mode has been specified.
If all communication modes are prohibited (modes 475 to 477), some
screens, such as those for specifying transmission settings, may not nor-
mally be displayed.
Factory settings
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 0 0 0 (HEX: 00)
Bit Description Setting Description Page Refer-
ence
7 Specifies whether or
not the use of TCP/
IP is prohibited.
0 Permitted ----------
1Prohibited
6 Specifies whether or
not the use of LPD is
prohibited.
0 Permitted ----------
1Prohibited
5 Specifies whether or
not the use of a
RAW port is prohib-
ited.
0 Permitted ----------
1Prohibited
4 Specifies whether or
not the use of SLP is
prohibited.
0 Permitted ----------
1Prohibited
3 Specifies whether or
not the use of a
Scan to FTP is pro-
hibited.
0 Permitted ----------
1Prohibited
2 Specifies whether or
not the use of an
FTP server is pro-
hibited.
0 Permitted ----------
1Prohibited