Filter
Top Products
Specifying management settings
9
200/250/350 9-57
Specifying management settings Chapter 9
*1 If bit 6 is set to “1”, the settings will not be applied if bit 5 is set to “1” (not
displayed). If you do not wish to display the fax number or address of the re-
cipient, bit 6 must also be set to “1” (settings can only be specified in Admin-
istrator mode).
*2 If the recipient is directly specified from the Direct Input tab, the recipient
is displayed, even if “1” (not displayed) is selected.
5 Specifies whether or
not only recipient
names are displayed
(and the fax number
or address is not
displayed) in reports
and Job List screens
and when a one-
touch dial button is
touched.
*
1,
*
2
0 Displayed ----------
1 Not displayed
4 -----------------------
0 *Do not change this bit
when specifying settings
for this function.
----------
3 Specifies whether or
not the use of TCP-
Socket is prohibited.
0 Permitted ----------
1Prohibited
2, 1, 0 -----------------------
000 *Do not change these bits
when specifying settings
for this function.
----------
Bit Description Setting Description Page Refer-
ence