Filter
Top Products
9
Specifying management settings
9-32 200/250/350
Specifying management settings Chapter 9
4 Specify the mode setting using either bit selection or HEX selection.
– To specify in bit values, touch [Bit Selection], touch [←] or [→] to
move the cursor to the bit to be changed, type in the value using
the keypad, and then touch [Enter].
– To specify in hexadecimal values, touch [HEX Selection], specify
the value by using the keypad and touching [A]—[F], and then touch
[Enter].
5 To change the settings for other modes, repeat steps 3 and 4.
6 Touch [Enter] until the initial screen appears.
7 Turn the machine off, then on again.
2
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off.
The machine may not operate correctly if it is turned on immediately after
being turned off.
Soft SW Setting
000
76543210
00110000
30
HEX Selection
Mode Selection
SetF
C
E
B
D
A
Bit Selection
Enter
Soft SW Setting
Enter
000
76543210
00110000
30
Bit Selection
Mode Selection
SetF
C
E
B
D
A
HEX Selection
100%
Memory
Free