Filter
Top Products
3: Operations
assigned outlets, groups and serial/Pass-Thru ports.
On-Only: Partial-access for control (On) , status and Pass-Thru of
assigned
outlets, groups and serial/Pass-Thru ports.
View-Only: Partial-access for status and Pass-Thru of assigned
outlets,
groups and serial/Pass-Thru ports.
The administrator may also grant administrative privileges to other user accounts,
allowing the SLP to have more than one administrative-level user.
Note: You cannot remove administrative privileges from the Admin user
unless another user has already been given administrative access level
privileges created.
1. Click on the Edit link in the Action column for the associated user.
2. On the subsequent User Edit page, select Admin, Power-User, User, Reboot-
Only, On-only or View-Only from the Access Level drop-down menu and press
Apply.
Granting or removing Environmental Monitoring viewing privileges:
1. Click on the Edit link in the Action column for the associated user.
2. On the subsequent User Edit page, select Yes or No from the Environmental
Monitoring drop-down menu and press Apply.
Adding and Deleting outlet access:
1. Click on the Outlets link in the Access column for the associated user.
2. On the subsequent User Outlets page, select or deselect outlets to be accessed
by the user and press Apply.
Adding and Deleting group access:
1. Click on the Groups link in the Access column for the associated user.
2. On the subsequent User Groups page, select or deselect group to be accessed
by the user and press Apply.
Adding and deleting serial port access:
1. Click on the Ports link in the Access column for the associated user.
2. On the subsequent User Ports page, select or deselect ports to be accessed by
the user and press Apply.
FTP
The FTP configuration page is used for setup and maintenance of all settings
required to perform an FTP firmware upload. See
Uploading Firmware on page [100]
for more information on uploading firmware.
Setting the FTP Host IP Address:
1. Enter the IP address in the Host IP Address field and press Apply.
Setting the FTP username:
SecureLinx SLP Remote Power Manager 24