Filter
Top Products
4: Advanced Operations
SLP: set snmp trapdest1 64.42.31.208<Enter>
The following sets the trap destination 2 to snmp.lantronix.com:
SLP: set snmp trapdest2 snmp.lantronix.com
<Enter>
To reset the trap destination:
1. At the command prompt, type set snmp, trapdest1 or trapdest2, 0.0.0.0
and press Enter.
Setting the trap timer
The Set Traptime command sets the timer period between repeated error-condition
traps. The valid range for the timer period is 1 to 65535 (in seconds).
The default value for the timer period is 60 seconds.
To set the trap timer:
1. At the command prompt, type set traptime, followed by the timer period and
press Enter.
Example
The following sets the timer period to 180 seconds:
SLP: set traptime 180<Enter>
Setting the Get/Set community strings
Two SNMP community strings provide varying levels of access to objects defined in
the private enterprise MIB extensions.
Community strings may be 1 to 24 characters.
Setcomm
The Setcomm string provides read-write access to private enterprise MIB objects.
The default Setcomm string is “private”
To set the Setcomm community string:
1. At the command prompt, type set snmp setcomm, followed by the string and
press Enter.
Getcomm
The Getcomm string provides read-only access to private enterprise MIB objects.
The default Getcomm string is “public”.
To set the Getcomm community string:
1. At the command prompt, type set snmp getcomm, followed by the string and
press Enter.
SecureLinx SLP Remote Power Manager 69