Filter
Top Products
3: Operations
1. Enter the IP address or hostname in the Primary and/or Secondary Host field and
press Apply.
Setting the Local GMT offset:
1. Select the local offset from GMT value from the drop-down menu and press
Apply.
Setting the Syslog server address:
1. Enter the IP address or hostname in the Primary and/or Secondary Host field and
press Apply.
Changing the Syslog server port number:
1. In the Syslog Port field, enter the port number and press Apply.
SNMP
The SNMP configuration page is used for setup and maintenance of all settings
required to enable SNMP support as well as access to the trap configuration pages.
For additional information on SNMP support and detailed descriptions of available
traps, see SNMP on page 68.
Note: Traps are generated according to a hierarchical architecture; i.e. if a
Tower (Unit) Status enters a trap condition, only the Tower Status trap is
generated. Infeed and Outlet Status traps are suppressed until the Tower
Status returns to Normal.
Enabling or disabling SNMP support:
1. Select Enabled or Disabled from the drop-down menu and press Apply.
Setting the community strings:
1. Enter the community string in the appropriate field and press Apply.
Community strings may be 1 to 24 characters
Setting the trap timer:
1. Enter a trap timer value in the Error Trap Repeat Time field and press Apply.
The Error Trap Repeat Time value may be 1 to 65535 (in seconds).
Setting trap destinations:
1. Enter an IP address or hostname in the appropriate Trap Destination field and
press Apply.
Setting IP restrictions:
1. Select No Restrictions or Trap Destinations Only from the IP Restrictions
drop-down menu and press Apply.
Note: When Trap Destinations Only is selected, SNMP Manager GET and
SET requests are only allowed from the IP addresses of the defined traps
destinations.
Setting the SNMP SysName, SysLocation or SysContact objects:
SecureLinx SLP Remote Power Manager 26