Filter
Top Products
3: Operations
H/W Rev Code: 0
Flash Size: 1 MB
Uptime: 0 days 6 hours 14 minutes 1 second
Location: Florida HQ
Setting the LED display orientation
The Set Option Display command is used to configure the Current LED(s) display
orientation.
To set the LED display orientation:
1. At the command prompt, type set option display, followed by normal or
inverted and press Enter.
Example
The following sets the LED display orientation to Inverted:
SLP: set option display inverted<Enter>
Note: When set to Inverted, the load will be reported in whole ampere
increments.
Enabling or disabling strong passwords
The Set Option Strong Passwords command is used to enable or disable the
requirements for strong passwords. When enabled, all new passwords must be a
minimum of 8 character in length with a least one uppercase letter, one lowercase
letter, one number and on special character.
To enable or disable strong passwords:
1. At the command prompt, type set option strong password, followed by
enabled or disabled and press Enter.
Enabling or disabling the external configuration reset button
The Set Option Button command enables or disables the external configuration reset
button. This feature can enhance system security by protecting the SLP
configurations from being reset locally.
Note: If this feature has been enabled and the administrative account
username/password has been lost, then the SLP must be returned to the
factory for no-warranty reset of the configuration.
To enable or disable the configuration rest button:
1. At the command prompt, type set option button, followed by enabled or
disabled and press Enter.
Enabling or disabling the ‘more’ prompt
The Set Option More command enables or disables the ‘more’ prompt for display of
data larger that the terminal window.
To enable or disable ‘more’:
SecureLinx SLP Remote Power Manager 54