Filter
Top Products
3: Operations
Ping
The Ping feature may be used to test the SLP’s ability to contact another Ethernet
enabled device’s IP address. For LDAP support, it may also be used to test the
configuration of the Domain Name server IP address by testing for proper name
resolution.
Change Password
The Change Password feature allows users to change their own password.
Note: An administrator can always
assign a new password.
Changing a password:
1. Enter the current password, enter a new password and verify the new password.
Press Apply.
View Log
The View Log feature enables viewing of the internal system log. This feature
logs all authentication attempts, power actions, configuration changes and
other system events. The system memory stores more than 4000 entries in a
continuously aging log. For permanent off-system log storage, the Syslog
protocol is supported. For additional information and configuration
requirements for the system log and Syslog support, see
Logging on page 93.
Note: The system log is viewable only by users with administrative
privileges.
Reviewing the system log:
Click on the Previous 200 entries or Next 100 entries link to navigate through the
log.
Restart
Performing a warm boot:
1. Select the Restart from the Action drop-down menu and press Apply.
Note: System user/outlet/group configuration or outlet states are NOT
changed or reset with this command.
Resetting to factory defaults:
See Resetting to Factory Defaults for more information on resetting a unit to factory
defaults from the HTML interface.
Uploading new firmware:
See Uploading Firmware for more information on uploading new firmware from the
HTML interface.
Generating a new SSL X.509 certificate:
SecureLinx SLP Remote Power Manager 32