Filter
Top Products
4: Advanced Operations
Load Trap
The Load trap is generated whenever the total input load on an infeed exceeds a
preset threshold. Load traps include the reported input load, load status, Location of
the unit, and identifier and name of the affected infeed.
Any error state generates a Load trap and triggers the trap timer. A new trap is
generated at the end of every timer period until the Load returns to a non-error
status.
Table 4-8. Load Traps
Status Error Description
Normal Infeed is on and within preset thresholds
NotOn Infeed is off
Reading Non-error state – Load status currently being read
LoadHigh x Infeed current load exceeds preset threshold
OverLoad x Infeed current load exceeds the measurable range
for the infeed
ReadError x Unable to read Load status
NoComm x Communication to the infeed
Configuring Traps
Table 4-9. SNMP Trap Command Summary
Command Description
Set Trap Unit Status Enables or disables the Unit Status trap
Set Trap Infeed
Status
Enables or disables the Infeed Status trap
off
Set Trap Infeed Load Enables or disables the Infeed Load trap
Set Trap Infeed
HighThresh
Sets the Infeed Load trap high limit
Set Trap Outlet
Change
Enables or disables the Outlet Change trap
Set Trap Outlet
Status
Enables or disables the Outlet Status trap
Show Traps Displays trap configurations
Enabling or Disabling a Status trap
The Set Trap <infeed|outfeed|outlet> Status command is used to enable or disable
Status traps for a Unit, Infeed or Outlet.
To Enable or Disable a Status trap:
1. At the command prompt, type set trap (unit, infeed or outlet) status,
followed by the tower, infeed or outlet name, and on or off. Press Enter, or
2. Type set trap (unit, infeed or outlet) Status all, followed by on or
off and press Enter.
Examples
SecureLinx SLP Remote Power Manager 73