Filter
Top Products
3: Operations
1. In the appropriate field, enter the SysName, SysLocation or SysContact objects
and press Apply.
Enabling or disabling tower (unit) traps:
1. Click on the Tower Traps link.
2. On the subsequent page, select or deselect the desired traps and press Apply.
Configuring input feed traps:
1. Click on the Input Feed Traps link.
2. On the subsequent Input Feed Traps page, select or deselect the desired traps
and press Apply.
3. For Load traps, enter a maximum load value for the infeed in the High Load
Threshold field and press Apply.
The High Load Threshold value may be 0 to 255 (in amperes).
Configuring outlet traps:
1. Click on the Outlet Traps link.
2. On the subsequent Outlet Traps page, select or deselect the desired traps and
press Apply.
Enabling or disabling Environmental Monitor traps:
1. Click on the Environmental Monitor Traps link.
2. On the subsequent page, select or deselect the desired traps and press Apply.
Configuring the Temperature-Humidity sensor traps:
1. Click on the Sensor Traps link.
2. On the subsequent page, select or deselect the desired traps and press Apply.
3. For Temp traps, enter a minimum and maximum threshold value for the sensor in
the appropriate field and press Apply.
The threshold value may be 0 to 127 degrees Celsius OR 32 to 254 degrees
Fahrenheit.
4. For Humid traps, enter a minimum and maximum threshold value for the sensor
in the appropriate field and press Apply.
The threshold value may be 0 to 100 (in percent relative humidity).
LDAP
The LDAP configuration page is used for setup and maintenance of all settings
required to enable LDAP support. For additional information and configuration
requirements, see LDAP on page 76.
Enabling or disabling LDAP support:
1. Select Enabled or Disabled from the LDAP drop-down menu and press Apply.
SecureLinx SLP Remote Power Manager 27