Filter
Top Products
3: Operations
Example
The following command adds the descriptive name Florida__HQ_1 to tower .a:
SLP: set tower name .a Florida_HQ_1<Enter>
Displaying Tower information
The Show Towers command displays information about the SLP. This information
includes the absolute and descriptive SLP names.
To display unit information:
1. At the command prompt, type show towers and press Enter.
Example
SLP: show towers<Enter>
Tower Tower
ID Name
.A Florida_HQ_1
Displaying the firmware version
The Version command displays the firmware version.
To display the firmware version:
1. At the command prompt, type version and press Enter.
Performing a warm boot
The Restart command performs a warm boot of the unit.
Note: System user/outlet/group/port configuration or outlet states are NOT
changed or reset with this command.
To perform a warm boot:
1. At the command prompt, type restart and press Enter.
TCP/IP Administration
Note: A restart of the unit is required after setting or changing any TCP/IP
configurations.
Enabling or disabling DHCP support
The Set DHCP command enables or disables DHCP support.
To enable or disable DHCP support:
1. At the command prompt, type set dhcp, followed by enabled or disabled and
press Enter.
Setting the IP address
The Set Ipaddress command sets the TCP/IP address of the network interface
controller.
To set the IP address:
SecureLinx SLP Remote Power Manager 57