Filter
Top Products
4: Advanced Operations
Displaying the LDAP configuration information:
• The Show LDAP command displays LDAP configuration information
• Enabled-disabled status of LDAP support
• Directory Services server IP address and port
• Bind request password type and remote authentication order
• Search bind distinguished name and password
• User search base distinguished name and filter
• Group membership attribute and type
Note: With the Remote Only method, if authentication fails due to a communication
failure with the Active Directory server, automatic authentication fallback will occur to
authenticate with the local user data base on the SLP device.
To display the LDAP configuration information:
1. At the command prompt, type show ldap and press Enter.
Example
The following command displays the LDAP configuration information:
SLP: show ldap
LDAP Configuration
LDAP: Enabled
Host 1: 98.76.54.32
Host 2: ldap.lantronix.com
Port: 8888
TLS/SSL: Yes
Bind Type: MD5
Auth Order: Remote -> Local
Search Bind
DN: cd=guest,cn=Users,dc=lantronix,dc=com
Password: OpenSesame
User Search
Base DN: cn=Users,dc=lantronix.com
Filter: (samaccountname=%s)
Group Membership
Attribute: memberof
Value Type: DN
Setting the DNS IP address:
The Set DNS command sets the TCP/IP address of the Domain Name server (DNS).
Note: LDAP requires the definition of at least one Domain Name server.
To display the DNS configuration information, use the Show Network command as
described in Displaying network configuration information on page 60.
To set the DNS IP address:
1. At the command prompt, type set followed by dns1 or dns2 and the Domain
Name server’s IP address. Press Enter.
Example
The following sets the primary Domain Name server IP address to 98.76.54.254:
SecureLinx SLP Remote Power Manager 82