Filter
Top Products
3: Operations
2. At the command prompt, type show network and press Enter.
Example
The following command displays the network configuration information:
SLP: show network<Enter>
Network Configuration
IP Address: 12.34.56.78
Subnet Mask: 255.0.0.0
Gateway: 12.34.56.1
Telnet: Enabled Port: 23
SSH: Enabled Port: 65535
HTTP: Enabled Port: 80 Security: BASIC
SSL: Enabled Access: Required
SNMP: Enabled
Network Status
Link: Up
Speed: 100 Mbps
Duplex: Full
Negotiation: Auto
HTTP Administration
Note: A restart is required after setting or changing ANY Telnet/Web configurations.
At the command prompt, type restart and press Enter.
Enabling and disabling HTTP support
The Set HTTP command is used to enable or disable HTTP support.
To enable or disable HTTP support:
1. At the command prompt, type set http, followed by enabled or disabled
and press Enter.
Changing the HTTP server port
With HTTP support enabled, the HTTP server watches and responds to requests on
the default HTTP port number 80. This port number may be changed using the Set
HTTP Port command.
To change the HTTP port:
1. At the command prompt, type set http port, followed by the port number
and press Enter.
Example
The following changes the HTTP port number to 2048:
SLP: set HTTP port 2048<Enter>
Setting the HTTP authentication method
The Set HTTP Security command is used to set the method of authentication. The
HTTP server supports two authentication methods for security and validation of the
username-password – Basic and MD5 digest.
To set the HTTP authentication method:
SecureLinx SLP Remote Power Manager 61