Filter
Top Products
slots on the bottom of the chassis underneath the fan cage assembly; then,
connect it to the ServeRAID-BR10i SAS/SATA controller as shown in the
following illustration:
1 Signal cable for drives 4-7
2 Adapter connector for drives 4-7 signal cable
3 Signal cable for drives 0-3
4 Adapter connector for drives 0-3 signal cable
Connect the single end of the power cable to the Hard disk drive
backplane power connector on the system board and connect the split
end of the power cable to the connectors on the backplane as shown in the
following illustration.
1 Power connector
2 Power cable
3 Backplane power connectors
v For the four drive-bay, 3.5-inch server model, connect the signal cable as
shown in the following illustration:
Chapter 5. Installing optional devices and replacing customer replaceable units 109