Filter
Top Products
1 Filler panels
2 Drive-bay EMC shield
3 Tab
4 Hard disk drive
3. Pull the loops of the drive assembly toward each other; then, carefully slide the
drive assembly into the drive bay until it stops and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.
4. Close the drive bay EMC shield.
5. Close the bezel.
6. Lock the side cover.
7. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
IDs for hot-swap hard disk drives
Hot-swap server models have drive bays that are connected to a SAS/SATA
backplane. This backplane, also known as the hot-swap-drive backplane, is the
printed circuit board behind these bays.
The hot-swap-drive backplane controls the IDs for the internal hot-swap drive bays.
The following tables list the IDs for the hard disk drives and backplane that are
connected to hot-swap models.
Table 4. IDs for the four-bay 3.5-inch hot-swap drive models
Drive bay number ID
Drive bay 4 0
Chapter 5. Installing optional devices and replacing customer replaceable units 77