Filter
Top Products
60
Chapter 6: Using the Web-based Utility
The Voice Tab
IP Telephony System
excl. NTFY to log the start-line only for all messages except NOTIFY requests/responses. Select 1-line excl. REG
to log the start-line only for all messages except REGISTER requests/responses. Select 1-line excl.
OPT|NTFY|REG to log the start-line only for all messages except OPTIONS, NOTIFY, and REGISTER
requests/responses. Select full to log all SIP messages in full text. Select full excl. OPT to log all SIP messages
in full text except OPTIONS requests/responses. Select full excl. NTFY to log all SIP messages in full text except
NOTIFY requests/responses. Select full excl. REG to log all SIP messages in full text except REGISTER
requests/responses. Select full excl. OPT|NTFY|REG to log all SIP messages in full text except for OPTIONS,
NOTIFY, and REGISTER requests/responses. The default is none.
RTP Log Intvl. Periodically, the System will log RTP statistics via syslog, depending on debug level. Enter the
period of time in seconds. The default is 0.
Restrict Source IP. If Lines 1 and 2 use the same SIP Port value and the Restrict Source IP feature is enabled,
then the proxy IP address for Lines 1 and 2 is treated as an acceptable IP address for both lines. To enable the
Restrict Source IP feature, select yes. Otherwise, select no. The default is no.
Referor Bye Delay. This controls when the System sends BYE to terminate stale call legs upon completion of call
transfers. Multiple delay settings (Referor, Refer Target, Referee, and Refer-To Target) are configured on this
screen. For the Referor Bye Delay, enter the appropriate period of time in seconds. The default is 4.
Refer Target Bye Delay. For the Refer Target Bye Delay, enter the appropriate period of time in seconds. The
default is 0.
Referee Bye Delay. For the Referee Bye Delay, enter the appropriate period of time in seconds. The default is 0.
Refer-To Target Contact. To contact the refer-to target, select yes. Otherwise, select no. The default is no.
Sticky 183. If this feature is enabled, then the IP Telephony will ignore further 180 SIP responses after receiving
the first 183 SIP response for an outbound INVITE. To enable this feature, select yes. Otherwise, select no. The
default is no.
Subscriber Information
Display Name. Enter the display name for caller ID.
User ID. Enter the extension number for this line.
Figure 6-38: Voice - FXS 1 Screen - Subscriber
Information
VoIPon Solutions www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0) 1245 600560