Filter
Top Products
Beyond the Basics
Reviewing or canceling delayed commands
If you’ve stored a delayed command in your fax machine, it will hold it in memory
until it either completes the command successfully or reaches its maximum number
of redial attempts (see pages 1.15–1.16). Your machine can store up to 99 delayed
commands. It identifies each by a two-digit command number ranging from 01 to 99.
To see your machine’s stored commands or to cancel them:
1
Press
REVIEW COMMANDS
.
• If there are no stored commands in your machine — It beeps briefly
and displays “No Command” on the
LCD
. It then returns to standby mode.
• If there are commands in your machine’s memory, the
LCD
shows:
Here, you see command 01, followed by the number it’s set to dial. If the com-
mand is to send a broadcast, “Broadcast” appears instead of the phone
number. (See “Broadcasting,” page 2.16.)
If the command is to send a batch transmission, the
LCD
shows its batch box
number (such as “B01”) rather than the command number. (See “Batch trans-
mission,” pages 2.20–2.23.)
If the command is for a continuous polling operation, the
LCD
shows its contin-
uous polling operation number (such as “P01”) rather than the command
number. (See “Polling,” on pages 2.29–2.31.)
Note: If your machine is attempting to perform a command now, it appears
on the display.
2
Press /
PROGRAM
or to scroll through currently stored commands.
3
If you want to cancel the command shown, press
CANCEL
. The
LCD
shows:
4
To keep this command but to continue reviewing stored commands, press
/
PROGRAM
. Go back to step 2.
To keep this command and stop reviewing commands, press
STOP
to return
your machine to standby mode.
To go ahead with cancelling the command, press
CANCEL
again. Go back to
step 2 to view other delayed commands.
Note: See also “Reviewing or cancelling parts of a broadcast,” next column.
Reviewing or cancelling parts of a broadcast
You also can review or cancel certain numbers within a broadcast:
1
Press
REVIEW COMMANDS
.
2
Press /
PROGRAM
or to scroll through currently stored commands.
Note: Stop this operation at any time by pressing
STOP
.
3
If you want to cancel the command shown, press
CANCEL
,
CANCEL
.
If you want to review individual numbers within this broadcast, go on to
step 4 without pressing
CANCEL
.
4
To review individual numbers within this broadcast, press
BROADCAST
to see
the first number. The
LCD
shows:
5
Press /
PROGRAM
or until you find the number you want to cancel.
6
Press
CANCEL
,
CANCEL
. The next number will appear.
If you want to cancel this number, also, repeat this step.
If you want to cancel a different number, go back to step 5.
If you don’t want to cancel any more numbers, press
STOP
. The machine
returns to standby mode.
9-5550388
Program/Cancel
C01:9-5552311
Check Program/Cancel
C01:9-5552311
Program/Cancel
2.18