NETGEAR D7000 Network Router User Manual


 
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, one of the following problems might be occurring:
Wrong physical connections
For a wired connection, make sure that the numbered LAN port LED is lit for the port to which you are
connected.
Check that the appropriate LEDs are on for your network devices. If your modem router and computer
are connected to a separate Ethernet switch, make sure that the link LEDs are lit for the switch ports
that are connected to your computer and modem router.
Wrong network configuration
Verify that the Ethernet card driver software and TCP/IP software are both installed and configured
on your computer.
Verify that the IP address for your modem router and your computer are correct and that the addresses
are on the same subnet.
Test the Path from Your Computer to a Remote Device
After you verify that the LAN path works correctly, test the path from your computer to a remote device:
1. From the Windows toolbar, click the Start button and select Run.
2. In the field provided, enter
ping -n 10 IP address
where IP address is the IP address of a remote device such as your ISP’s DNS server.
If the path is functioning correctly, replies as described in Test the LAN Path to Your Modem Router on
page 305 display. If you do not receive replies, do the following:
Check to see that the IP address of your modem router is listed as the default router in your computer.
If the IP configuration of your computer is assigned by DHCP, this information is not visible in your
computer’s Network Control Panel. Verify that the IP address of the modem router is listed as the
default router.
Check to see that the network address of your computer (the portion of the IP address specified by
the netmask) is different from the network address of the remote device.
If your ISP assigned a host name to your computer, enter that host name as the account name. For
more information, see one of the following sections:
Specify an ADSL Connection Without a Login Requirement on page 51
Specify a VDSL Connection Without a Login Requirement on page 63
Specify a Cable or Fiber Connection Without a Login Requirement on page 74
Your ISP might be rejecting the Ethernet MAC addresses of all but one of your computers.
Many broadband ISPs restrict access by allowing traffic only from the MAC address of your modem,
but some additionally restrict access to the MAC address of a single computer connected to that
Diagnostics and Troubleshooting
306
Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000