Filter
Top Products
ACCULINK 316x DSU/CSU
3-64 December 1996 3160-A2-GB22-10
3. From
the Control screen, press F1 to select Call.
F1
Control:
Call Rel LED
F2
F3
4.
From the Call Setup screen, press F1 to select
Pass.
F1
Call
S
etup:
Pass Dial ChDir
F2
F3
5. From the Pass Directory screen, press F1 (Up) to
display the next higher numbered directory or
press F2 (Down) to select the next lower
numbered directory.
F1
Pass
n
: xxxxxxxxx
Up Down Dial
F2
F3
6. When the number of the desired directory appears
on the screen, press F3 (Dial) to place the call.
Initiating a Call for PC, ASCII Terminal/Printer,
Async Terminal, or SNMP Operation
Use
the Dial command to set up a semipermanent
connection to route alarm messages to the specified
destination. The Dial command initiates a call through the
integral modem to a PC, ASCII terminal/printer
, or async
terminal.
To initiate a call at the local DSU/CSU,
1.
Press the
key on the top-level menu screen to
bring the Ctrl branch onto the front panel LCD.
F1
DS
U E
SF
Stat Test Cnfig
F2
F3
2. Press F3 to select Ctrl from the top-level menu
screen.
F1
DS
U E
SF
Test Cnfig Ctrl
F2
F3
3. From
the Control screen, press F1 to select Call.
F1
Control:
Call Rel LED
F2
F3
4.
From the Call Setup screen, press F2 to select
Dial. This selection is not available if the
DSU/CSU’s integral modem is currently active.
F1
Call
S
etup:
Pass Dial ChDir
F2
F3
5. From the Dial Directory screen, press F1 (Up) to
display the next higher numbered directory or
press F2 (Down) to select the next lower
numbered directory.
F1
Dial
n
: xxxxxxxxx
Up Down Dial
F2
F3