Filter
Top Products
Configuration Options
C-233160-A2-GB22-10 December 1996
Table C-10
(2 of 2)
SNMP Trap Configuration Options
Link Trap: Both
Next Disab Up Down Both Prev
Link Trap Type. Specifies the link trap type to enable. Interfaces monitored for link-up and link-down traps can be
specified with the Trap I/F configuration options.
Disab – Disables the sending of trap messages for linkDown and linkUp events to the currently configured trap
manager(s).
Up – Sends trap messages for linkUp events to the currently configured trap manager(s). A linkUp trap signifies the unit
recognizes that one of the communication interfaces has come up.
Down – Sends trap messages for linkDown events to the currently configured trap manager(s). A linkDown trap signifies
the unit recognizes a failure in one of the communication interfaces.
Both – Sends trap messages for linkDown and linkUp events to the currently configured trap manager(s).
NOTE: This configuration option is not available and is not displayed if the SNMP Trap alarm configuration option is
disabled.
Trap I/F: All
Next NET DTE T1s Ports All Prev
Link Trap Interfaces. Specifies which interfaces send linkUp and linkDown trap messages. These traps are supported on
the T1 interfaces only.
NET – Sends trap messages for linkDown and linkUp events on the network T1 interface only.
DTE – Sends trap messages for linkDown and linkUp events on the DTE Drop/Insert T1 interface only.
T1s – Sends trap messages for linkDown and linkUp events on both the network and DTE Drop/Insert T1 interfaces.
Ports – Sends trap messages for linkDown and linkUp events on synchronous data ports only.
All – Sends trap messages for linkDown and linkUp events on the network and DTE Drop/Insert T1 interfaces, and the
synchronous data ports.
NOTE: This configuration option is not available and is not displayed if the Link Traps configuration option is not
configured to generate trap messages for linkUp and linkDown events.