Filter
Top Products
Introduction 155
Access Server Administrators’ Reference Guide 12 • Ethernet
Introduction
The access server provides management and statistical information in the
Ethernet
window (see figure 66).
Detailed information regarding the SNMP MIB II variables may be downloaded from RFC 1643, Definitions
of Managed Objects for the Ethernet-like Interface Types.
Click on
Ethernet
under the
Configuration Menu
to display the
Ethernet m
ain window.
The
Ethernet
main window displays information about the configuration of the Ethernet interface including IP
addresses, subnet masks, and state of the Ethernet link.
The ethernet interface contains the following links:
•
Statistics
link—Clicking on the
Statistics
link takes you to the page where you can see the statistics on the
ethernet interface. For more information about the
Statistics
page, refer to “Ethernet Statistics” on
page 158.
•
Modify
—Clicking on the
Modify
link takes you to the page where you can change the configuration of your
ethernet interface. For more information about modifying Ethernet settings, refer to
“Ethernet Modify
Window” on page 157.
Figure 64. Ethernet Main Window
Ethernet Main Window
The
Ethernet
main window shows the current configuration of the ethernet interface. The following sections
describe each parameter.
State (boxEtherAState)
Indicates the state of the ethernet interface. The following states are valid:
• notInstalled(0)—Ethernet interface is not installed in the hardware
• noLinkIndication(1)—The link is in the “down” state
• adminOff(2)—The link is administratively down
• linkIndication10M(3)—The link is up and running at 10M half duplex
• linkIndication10Duplex(4)—The link is up and running at 10M full duplex
• linkIndication100M(5)—The link is up and running at 100M half duplex
• linkIndication100Duplex(6)—The link is up and running at 100M full duplex