Filter
Top Products
RIP Version 2 main window 221
Access Server Administrators’ Reference Guide 18 • RIP Version 2
• ripVersion1 (2)—Send RIP updates compliant with RFC 1058
• rip1Compatible (3)—Broadcast RIP-2 updates using RFC 1058 route subsumption rules
• ripVersion2 (4)—Send multicasting RIP-2 updates
Receive (rip2IfConfReceive)
This indicates which version of RIP updates are to be accepted. Note that rip2 and rip1OrRip2 implies recep-
tion of multicast packets.
• rip1 (1)—Accept RIP updates compliant with RFC 1058
• rip2 (2)—Accept multicasting RIP-2 updates
• rip1OrRip2 (3)—Accept both
• doNotRecieve (4)
Adding a RIP address
Do the following:
1. Enter the IP network address of the interface on the access server that you want to enable RIP. This is not
the IP address of the device you want to direct RIP packets to.
2. Enter the protocol version to be used for sending RIP packets. The following choices are available:
– doNotSend (1)
– ripVersion1 (2)—Broadcasting RIP updates compliant with RFC 1058
– rip1Compatible (3)—Broadcasting RIP-2 updates using RFC 1058 route subsumption rules
– ripVersion2 (4)—Multicasting RIP-2 updates
3. Enter the protocol version to be used for receiving RIP packets. The following choices are available (note
that rip2 and rip1OrRip2 implies reception of multicast packets):
– rip1 (1)—Accept RIP updates compliant with RFC 1058
– rip2(2)—Accept multicasting RIP-2 updates
– rip1Orrip2(3)—Accept both
– doNotReceive(4)
4. Click on
Submit
.
Further modifications can be made by clicking on the
Address
link of the specific subnet (see “RIP Version
2—Configuration”).