Patton electronic 6511RC Switch User Manual


 
5 • Troubleshooting and maintenance Model 6511RC User Manual
86 Matrix Switch test tools
Matrix Switch test tools
For the purpose of testing and troubleshooting the STM-1 link, the DS0 Mapping definitions, and H.110 bus
connectivity, the Model 6511RC Matrix Switch offers the following tool sets:
Loopback test modes for the Matrix Switch STM-1 port
SDH Section Trace and SDH Path Trace functions for the STM-1 link
The following sections describe these tool sets in detail.
Loopback test modes for the STM-1 port
The Matrix Switch provides the following diagnostic loopback test modes for the STM-1 port:
SDH facility loop (see section “Facility Loop [sonetFacilityLoop(1)]” on page 87)
SDH terminal loop (see section “Terminal loop [sonetTerminalLoop(2)]” on page 88)
H.110 loop (see section “Other Loop [sonetOtherLoop(3)]” on page 90)
The facility and terminal loops are specified by the SDH protocol. The H.110 loop is proprietary to the Fore-
Front Matrix Switch, and fulfills the SDH specification for a third vendor-defined loop.
Off There is NO Ethernet frame activity on either of the 10/100/1000
Ethernet ports. No action recommended
READY Front
panel
Blue On Indicates module is ready for removal from cPCI chassis.
Off Indicates module NOT ready for removal from cPCI chassis.
Do not remove card from chassis.
ALARM Rear
blade
Yellow
On solid A minor alarm condition has been detected.
Flashing A major alarm condition has been detected.
Off The Model 6511RC is operating normally. No action recommended.
READY Rear
blade
Blue On Card ready for removal from cPCI chassis.
Off Card not ready for removal from cPCI chassis.
Do not remove card from chassis.
ON LINE
On Reserved for future use
Off Reserved for future use
10/100
ENET
Front
Panel
Green On Ethernet Link is established
Integrated
LEDs on RJ-
45 connec-
tor
Off No Ethernet link is established
Yellow
On Flashes to indicates Ethernet frame activity on this port
Off Indicates no Ethernet frame activity on this port
READY Blue On Card ready for removal from cPCI chassis.
Off Card not ready for removal from cPCI chassis.
a. This LED provides status indications for the STM-1 WAN link established via the optical or electrical ports on
the Rear Module of the 6511RC
Table 6. LED status indications and recommended actions (Continued)
LED Location Color Status Meaning