Polycom MGC-50/MGC-100 Network Router User Manual


 
MGC Hardware and Installation Manual
2-35
First Entry IP Configuration
This following section describes the first entry IP Configuration for
pSOSystem and XPEK Operating Systems.
IP Configuration Change on XPEK and pSOS OS
1. Connect a Hub or cross-over LAN cable between the laptop’s LAN
connection and the LAN connection of the Control Unit.
2. On the laptop, click Control Panel ->Network Connection->Local
Area Connection.
3. In the Local Area Connection - General dialog box
, click the Properties
button.
4. In the Local Area Connection Properties dialog box and click Use the
following IP address.
5. Type the IP address 129.254.4.7 (of the laptop as part of the network
segment on the MCU).
6. Click OK.
7. Run the MGC Manager application.
8. Define a new MCU:
a. In the Browser pane, right-click the MCUs Network icon, and then
click New MCU.