Filter
Top Products
90 DOMINION KX II USER GUIDE
3. In the Name, Contact, and Location fields, type the SNMP Agent’s (this Dominion unit’s)
name as it appears in the KX II Console interface, a contact name related to this unit, and
where the Dominion unit is physically located, respectively.
4. Type the Agent Community String (the Dominion unit’s string). An SNMP community is
the group that devices and management stations running SNMP belong to; it helps define
where information is sent. The community name is used to identify the group; an SNMP
device or agent may belong to more than one SNMP community.
5. Specify whether the community is Read-Only or Read-Write using the Type drop-down list.
6. Configure up to five SNMP managers by specifying their Destination IP, Port #, and
Community.
7. Click on the Click here to view the Dominion-KX2 SNMP MIB link to access the SNMP
Management Information Base.
8. Click OK.
Syslog Configuration
Figure 62: Syslog Configuration
To configure the Syslog (enable Syslog forwarding):
1. Check the Enable Syslog Forwarding option to log the device’s messages to a remote
Syslog server.
2. Type the IP Address of your Syslog server in the IP Address field.
3. Click OK.
To cancel without saving changes:
Click Cancel.
To reset to factory defaults:
Click the Reset To Defaults button.