Filter
Top Products
CHAPTER 14: CC UNMANAGE 135
Chapter 14: CC Unmanage
Overview
When a Dominion KX II device is under CommandCenter Secure Gateway control and you
attempt to access the device directly using the Dominion KX II Remote Console, the following
message is displayed (after entry of a valid username and password):
Figure 104: Device Managed by CC-SG Message
Removing Dominion KX II from CC-SG Management
Unless the Dominion KX II is released from CC-SG control, you cannot access the device
directly. If, however, the KX II does not receive heartbeat messages from CommandCenter (e.g.,
CommandCenter is not on the network), you can release the KX II from CC-SG control in order
to access the device. This is accomplished by using the CC Unmanage feature.
Note: Maintenance permission is required to use this feature.
When no heartbeat messages are received, the following message is displayed when attempting to
access the device directly:
Figure 105: Remove from CC-SG Management