Filter
Top Products
Chapter 7: Device Management
136
2. If you are plugging power input into power supply number one
(left-most power supply at the back of the unit), then select the
Powerln1 Auto Detect option.
3. If you are plugging power input into power supply number two
(right-most power supply at the back of the unit), then select the
Powerln2 Auto Detect option.
4. Click OK.
Note: If either of these checkboxes is selected and power input is not
actually connected, the power LED at the front of the unit turns red.
To turn off the automatic detection:
Deselect the checkbox for the appropriate power supply.
To reset to factory defaults:
• Click the Reset To Defaults button.
Note: The Dominion KX II does NOT report power supply status to
CommandCenter. Dominion I (generation 1), however, does report
power supply status to CommandCenter.