Filter
Top Products
Other Functions
89
2
❒
In Connect Copy mode, you cannot use the Interrupt Copy function when
memory on the sub-unit is full.
❒
In Connect Copy mode, after finishing the interrupt copy job on the sub-unit,
be sure to exit Interrupt mode on the sub-unit. When you exit Interrupt mode,
the two machines automatically share the rest of the connect copy job.
❒
In Connect Copy mode, if the connect copy job is finished before finishing the
interrupt copy job on the sub-unit, be sure to exit Interrupt mode on the sub-
unit. If you do not exit Interrupt mode, the next connect copy job cannot be
started.
To interrupt an original being fed
A Press the
{
Interrupt
}
key.
The Interrupt indicator goes on and scanning stops.
B Remove the originals that were being copied and set the originals you wish
to copy.
C Press the
{
Start
}
key.
The machine starts making your copies.
D When your copy job is finished, remove your originals and copies.
E Press the
{
Interrupt
}
key again.
The Interrupt indicator goes off.
F When the display prompts you to, replace the originals that were being
copied before.
G Press the
{
Start
}
key.
The previous copy job settings will be restored and the machine will continue
copying from where it left off.
To interrupt copying after all originals have been fed
A Press the
{
Interrupt
}
key.
The Interrupt indicator goes on.
Note
❒
Copying will not stop yet.
B Set your original.
C Press the
{
Start
}
key.
The machine stops the original job and starts copying your original.