Filter
Top Products
What to Do If Something Goes Wrong
252
5
Connect Copy
Machine Status Problem/Cause Action
The [
Connect
] key does not
appear on the display.
The main power switch on
the sub-unit is off.
Turn on the sub-unit main
power switch.
The operation switch on
the sub-unit is off.
Press the operation switch
on the right side of the con-
trol panel. The
On
indica-
tor will goes on.
Note
❒
The machine will be
ready to operate about
five minutes after turn-
ing power on.
The master unit is not in
Copy mode (i.e., in Docu-
ment Server mode).
Press the
{
Copy/New Job
}
key on the master unit to
switch to Copy mode.
The master unit is in Inter-
rupt mode.
Press the
{
Interrupt
}
key on
the master unit to exit In-
terrupt mode.
The master unit is in Job
Preset mode.
Exit Job Preset mode in one
of the following ways.
❖
If you are still selecting
copy settings and copy-
ing has not started yet:
Press the [
Cancel
] key
then remove the origi-
nals set in the master
unit document feeder.
❖
If Job Preset mode is in
progress:
Press the
{
Clear/Stop
}
key, follow the instruc-
tions on the display
then press the [
Cancel
]
key.
Reference
See
⇒
P.83
“Job Preset”
.