Filter
Top Products
218
Setting Films in the Holder (If Needed)
Check which type of holder you should use. ☛ See page 216.
Slide Holder/Glass Mount Film Holder
Note
❐ The slide holder is covered with glass. Set the mount films in the slide holder.
❐ The glass mount film holder is not covered with the glass. Set the glass mount films (covered by glass) in the glass
mount film holder.
❐ Positive films are usually set in a slide mount or glass mount. If you use positive film not set in a mount, set it in the film
strip holder. ☛ See below.
1
Open the cover of the slide holder or glass mount
film holder, and set the slides in the holder one
by one.
Note
❐ Set the front side of the film face down when setting
in the slide holder or glass mount film holder.
❐ When setting in the slide holder, make sure that all
slides are aligned with the glass of the slide holder
cover.
2
Close the holder and lock it.
Film Strip Holder
Note
❐ Negative film usually come in stripes.
❐ Follow this procedure for positive strip film as well.
1
Open the film strip holder. Put the front side of
the film face down and set it in the film strip
holder.
Note
❐ When setting film, leave the base film in the film strip
holder. This is convenient when performing shading
again.
2
Adjust the position of the film.
Note
❐ Do not touch the image parts of the film when adjust-
ing.
3
Close the film strip holder and lock it .
Preparing the Film
TRSR0L0E
5
1
2
TRSR0K0E
TRSR0W0E
1: Back
2: Front