Filter
Top Products
226
Negative Film on Glass
1
Press the [Shading] key.
2
Insert the “N” (Negative) filter in the left slot as
shown in the illustration.
Note
❐ Be careful to insert the filter as shown, not the other
way around.
3
Cut the positioning sheet to match the film size.
Reference
Regarding the positioning sheet, ☛ see page 219.
4
Place the positioning sheet under the mirror unit
(on the exposure glass).
Note
❐ Place the marked corner of the film position sheet at
the rear left corner of the exposure glass.
❐ Before going to the next step, make sure that the
fresnel lens is lowered in position.
5
Set the base film in the film strip holder.
❐ Regarding setting the base film, ☛ see page 217.
6
Open the film cover and while pressing the holder
lever to the left, insert the film strip holder in the
right slot.
7
Insert the holder until the ★ mark is placed as
shown in the illustration.
TRSR0Y0E
TRSR0G0E
1
1. Positioning sheet
TRSR0F0E
1
1: Filter
TRSR0J0E
1
1: Holder lever
Selecting the Film Type and Performing Shading