Ricoh AP306D Printer User Manual


 
Paper and Other Media
26
3
Remove any unused adhesive labels from the tray after you are finished
printing. Leaving them in the tray can cause them to curl.
When printing on adhesive labels, you should select the plain paper mode
with the printer driver.
The bypass tray can hold up to 40 adhesive labels.
Note
The number of sheets to be set may vary depending on the paper thick-
ness and paper type.
In duplex printing, do not use adhesive labels.
OHP transparencies
When printing on OHP transparencies, use the bypass tray.
Load OHP transparencies into the tray with the print side face down or
they may stick to the fusing unit and cause a misfeed.
Remove any unused OHP transparencies from the tray after you are fin-
ished printing. Leaving them in the tray may cause them to stick together.
When printing on OHP transparencies, you should select the OHP trans-
parency mode with the printer driver.
The bypass tray can hold up to 50 OHP transparency sheets.
Note
The number of sheets you can set varies depending on the paper thick-
ness and paper type.
In duplex printing, do not use OHP transparencies or they may stick to the
fusing unit and cause a misfeed.
When the “OHP Slip” setting is set to “Off” ( P.83 “Using the Operation
Panel”), be sure to remove each OHP transparency immediately after it is
printed.
Note
If the direction and size of paper loaded in the paper tray is different
from the direction and size of the OHP transparency, “OHP Slip” will
not work even if it is on. Be sure to remove each OHP transparency im-
mediately after it is printed.
TFWY060E