Filter
Top Products
Troubleshooting
38
4
Error & Status Messages on the Operation Panel
Important
❒
If the error message that is not included in the following table appears on the
panel display, turn the printer off and on. If this does not clear the error mes-
sage, write down the error number and the message, and contact your sales
or service representative.
Note
❒
The panel display can show only one error message at a time. Printing a con-
figuration page shows all current printer errors. ⇒ P.99 “Printing the Configu-
ration Page”
❒
For more information about the IPDL-C printer driver, see the printer driver's
Help.
❒
For more information about the RICOH-SCRIPT2 printer driver, see the “Op-
erating Instructions” for RICOH-SCRIPT2 included as a PDF file on the CD-
ROM.
Message Description Comments
Add Fuser Oil
(on the upper line)
The fuser oil bottle is emp-
ty.
Replace the fuser oil bottle.
⇒
P.76 “Replacing the Fuser
Oil Bottle and Ozone Filter”
Add Fuser Oil
(on the lower line)
Fuser oil is low. You can
print about 200 or /more
pages after this message
appears.
Replace the fuser oil bottle.
⇒
P.76 “Replacing the Fuser
Oil Bottle and Ozone Filter”
Add Toner
Please Wait
The toner cartridge is being
prepared for replacement.
Wait for a while.
Add Toner
xxx
The indicated toner runs
out.
Replace the indicated toner
cartridge.
⇒
P.71 “Replacing Toner
Cartridge”
Call Service
SC:xx
There is a malfunction in
the printer.
Turn the printer off and on.
If this does not clear the
problem, contact your sales
or service representative.
Change Fuser It is time to replace the fus-
ing unit.
Contact your sales or ser-
vice representative.
Change PCU. It is time to replace the pho-
toconductor unit.
If prints are dirty, replace
the photoconductor unit.
⇒
P.74 “Replacing the Photo-
conductor Unit”