Filter
Top Products
Troubleshooting
80
4
E
Holding the green inset grips of
the new photoconductor unit,
push the unit back to its original
position.
F
Close the front cover.
Confirm that the front cover closes
properly.
G
Turn on the printer’s power
switch.
Replacing the Charger
Replace the charger whenever the fol-
lowing message appears on the panel
display.
IPDL-C
Need Chargerr
R
WARNING:
R
CAUTION:
Note
❒
Before removing the charger from
the printer, spread paper or some
other material around the area you
are working to keep toner from
making floor dirty.
A
Turn off the printer’s power
switch.
B
Push the front cover release but-
ton and open the front cover.
C
Holding the green inset grips of
the photoconductor unit, pull the
top of the unit forward.
•
Do not incinerate spilled toner
or used toner. Toner dust
might ignite when exposed to
an open flame.
•
Disposal can take place at our
authorized dealer or at appro-
priate collection sites.
•
If you dispose of the used ton-
er containers yourself, dis-
pose of them according to
your local regulations.
•
When accessing the inside of the
machine, do not touch any sec-
tions other than those specified
in this manual. If you do, it might
result in receiving a burn or inju-
ry.
TFWX080E
TFWX250E